Installing Reel-Easy String Head - Toro 51958 Manual Del Operador

Installing REEL-EASY
See Figures 20 - 21.
Stop the engine and disconnect the spark plug wire.
latches on each side. The contents of the string head are
spring loaded, so keep your other hand over the string
head cover while depressing the latches.
aside.
Place the upper housing on the drive shaft. Make sure
the string head is fully seated.
tighten. Turn clockwise for curved shaft and counter-
clockwise for straight shaft to tighten.
Straight Shaft
Curved Shaft
22
™ String Head
Cover
Latches
Knob
Spool
Spring
Hex Bolt
String Head
Latch
Opening
Figure 20
Note:
could damage the string head.
If removed, replace the spring into the string head and
push down to seat.
Replace the string head cover, aligning latches with
openings in the string head. Press cover and string head
manual.
Hex-Shaped
Opening
Knob
Hex Bolt
Figure 21
Maintenance