Starting The Product; Stopping The Product - Toro 51958 Manual Del Operador

6.

starting the product.

Note:
WARNING:
remove fuel cap or add fuel to a machine with
a running or hot engine. Make sure the unit is
outdoors. If the engine is hot, let the unit cool
After fueling, immediately replace fuel cap and
Failure to follow these instructions could result
Starting the Product
See Figures 6 - 7.
To Start a Cold Engine:
Follow these steps to start a cold engine.
1.
2.
FULL CHOKE
3. Set the choke lever to
4. Depress trigger lock-out and squeeze throttle trigger
HALF CHOKE
5. Set the choke lever to
6. Pull starter grip and rope until engine runs, no more
than 6 pulls.
RUN
7. Set the choke lever to
Note: In cooler environments, additional pulls of the
FULL CHOKE
lever in the
On/Stop
Lock-out
Switch
Switch
Throttle
Primer
Trigger
Bulb
Operation
-
.
.
.
position.
Starter
Grip and
Rope
Figure 6
Set Choke to FULL
To Start a Warm Engine:
Follow these steps to start a warm engine.
1.
2.
RUN
3. Set the choke lever to
4. Depress trigger lock-out and squeeze throttle trigger
fully, pull the sstarter grip and rope.
Note: If the product does not start, repeat the previous
steps.

Stopping the Product

See Figure 8.
Follow these steps to stop the product.
1. Release the trigger.
2. Press and hold on/stop switch to (STOP) position until
the engine stops. The switch will automatically return to
the (ON) position when released.
Throttle
Trigger
Set Choke to RUN
Figure 7
.
On/Stop
Switch
Figure 8
15