Carat T-5010 Manual De Instrucciones página 30

GB
a) move the leg clamps to the released position
(photo 1A).
b) use the transporting handles to lift the rear side
(motor side) to the working position (photo 1).
WARNING !
TO POSITION THE MACHINE CORRECTLY,
ENSURE THAT THE UPPER HOLE IN THE LEGS
IS ALIGNED WITH
CONNECTION BEFORE FINALLY CLAMPING IT
(PHOTO 2).
2 2
c) lock the legs in position one at a time (photo 2).
WARNING !
SUPPORT THE MACHINE WHILE LOCKING THE
LEGS IN POSITION.
d) repeat this operation on the front.
WARNING !
IF THE LEGS COME OUT COMPLETELY,
REPOSITION THEM USING THE 4 HOLES AT
THE BOTTOM ON THE OUTSIDE (photo 1).
Using a 6 mm allen wrench to attach the working
surface handle as indicated in photo 3.
3 3
THAT IN THE LEG
4. Fitting and removing the diamond tipped disc
Slacken the 5 (five) nuts on the disc guard and
remove it.
Remove the locking nut on the disc using the 30
mm spanner and the 5 mm allen wrench.
4 4
WARNING !
THE DISC LOCKING NUT HAS A LEFT-HAND
THREAD.
• fit the disc, paying careful attention to the
rotation direction clearly shown on the tool.
• Tighten the disc and replace the disc guard.
INFORMATION
THE FOLLOWING STEPS ARE RECOMMENDED
WHEN REMOVING THE DISC.
Wearing gloves to protect the hands, grip the diamond
tipped disc firmly and, with the other hand, unscrew
the locking nut using a 30 mm spanner.
5 5
30