Carat T-5010 Manual De Instrucciones página 35

2 2 0 0
- insert a 5 mm allen wrench into the hexagonal
hole in the bulb (photo 19)
- use the allen wrench to turn the bulb until the
mark is aligned with the cutting axis of the tool
(photo 20).
WARNING !
WHEN ADJUSTING, ENSURE THAT THE LINE
PRODUCED BY THE MARKER DOES NOT
SHINE IN THE OPERATOR'S EYES (PHOTO 21).
WARNING !
ALWAYS KEEP A SAFE DISTANCE BETWEEN
THE OPERATOR'S EYES AND THE END OF THE
BEAM (PHOTO 21).
WARNING !
THE MANUFACTURER
RESPONSIBILITY WHERE THE LASER MARKER
IS USED OTHER THAN AS INDICATED.
2 2 1 1
ACCEPTS NO
35
11. Maintenance
CLEANING
WARNING !
DO NOT WASH THE MACHINE WITH A
PRESSURIZED WATER JET.
Drain working residue from the machine using the
plug on the bottom of the collection tank.
Clean the sprayer periodically as shown (photos 22
and 23).
2 2 2 2
2 2 3 3
Clean cutting residue off the sliding guides
periodically (photo 24).
2 2 4 4
GB