Important Remarks - Allmatic BEVK4 Manual De Instrucciones

IMPORTANT REMARKS

TECHNICAL FEATURES
INSTALLATION TyPE
ExTERNAL DIMENSIONS
PREPARATION FOR AUTOMATION OF THE BASE
ASSEMBLy
UNLOCK
ADJUSTMENT OF ROD ANGLE
INVERSION OF DIRECTION OF OPENING
BALANCING
DISPOSAL
IMPORTANT REMARKS
For any installation problems please contact Allmatic S.r.l. TEL. (+39) 0437 751175
Allmatic S.r.l. has the right to modify the product without previous notice; it also declines any responsibility to damage
or injury to people or things caused by improper use or wrong installation.
Please read this instruction manual very carefully before installing and programming your
control unit.
• This instruction manual is only for qualified technicians, who specialize in installations and automations.
• The contents of this instruction manual do not concern the end user.
• Every programming and/or every maintenance service should be done only by qualified technicians.
AUTOMATION MUST BE IMPLEMENTED IN COMPLIANCE WITH THE EUROPEAN REGULA-
TIONS IN FORCE:
EN 60204-1 (Machinery safety. electrical equipment of machines, part 1: general rules)
EN 12445 (Safe use of automated locking devices, test methods)
EN 12453 (Safe use of automated locking devices, requirements)
• The installer must provide for a device (es. magnetotermical switch) ensuring the omnipolar sec-
tioning of the equipment from the power supply. The standards require a separation of the contacts
of at least 3 mm in each pole (EN 60335-1).
• The plastic case has an IP55 insulation; to connect flexible or rigid pipes, use pipefittings having
the same insulation level.
• Installation requires mechanical and electrical skills, therefore it shall be carried out by qualified
personnel only, who can issue the Compliance Certificate concerning the whole installation (Ma-
chine Directive 2006/42/CEE, Annex IIA).
• The automated vehicular gates shall comply with the following rules: EN 13241-1, EN 12453, EN
12445 as well as any local rule in force.
• Also the automation upstream electric system shall comply with the laws and rules in force and be
carried out workmanlike.
• The door thrust force adjustment shall be measured by means of a proper tool and adjusted ac-
cording to the max. limits, which EN 12453 allows.
• We recommend to make use of an emergency button, to be installed by the automation (connect-
ed to the control unit STOP input) so that the gate may be immediately stopped in case of danger.
• The appliance has not to be used by children or persons with reduced physical, sensory or men-
tal capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction.
• Children being supervised do not have to play with the appliance.
INDEX
8
8
9
9
10
11
12
12
12
13
13
13