Temperature Measurement - KPS MF50 Manual De Funcionamiento

KPS-MF50 • Enviromental tester
voltage is more than 7V, because the working current is higher and the volt-
age will decline. (When "
not be assured.) You need not replace the battery. When you use normally
(back light is not using), "
"show again.
4.5 AVG/MAX/MIN/DIF measurement
When One press the "MODE" button, you can select AVG/MAX/MIN/DIF(MAX-
MIN) value to measure.

4.6 Temperature measurement

PFor measurement, place the sensor probe in the tested environment. Press
the button "TEMP/%RH" to measure at 20 minute later. When the meter was
first power on, the default scale setting is set at Fahrenheit ºF scale. The user
may change it to Celsius ºC by pressing "UNIT" button and vice versa to Fahr-
enheit by pressing "UNIT" button again.
4.7 Humidity measurement
For measurement, place the sensor probe in the tested environment. When
Press the "TEMP/%RH" two times at 20 minute later, the meter will enter Hu-
midity measurement mode, the response time of the sensor is 5 second.
4.8 Sound level (dB) measurement
Move the sensor in front of the meter to the sound source. Press the "dB"
button to measure, and than the LCD display will show the Sound level at the
meter . When the meter was first power on, the default scale setting is set at
A-Weighting scale. The user may change it to C-Weighting by pressing "UNIT"
button and vice versa A-Weighting by pressing "UNIT" button again.
Note:
Strong wind striking the microphone call cause misreading for measurement in
windy locations, a windscreen should be used in front of microphone.
4.9 Illuminance(Lux) measurement
Move the sensor in front of the meter to light source in a horizontal position.
Press the "Lux" button to measure, and than the LCD display will show the il-
luminance at the meter.
" shows, the accuracy of the measurement can
" will not show up. You need replace it till "
19