Air Flow Measurement; Battery Replacement - KPS MF50 Manual De Funcionamiento

4.10 Air speed measurement
For measurement, place the sensor probe of anemometer in the tested envi-
ronment and to be sure the fan is in a uprightness position to the air current and
than press the "ANEMO" button to measure. When the meter was first power
on, the default scale setting is set at m/s scale. The user may change it to km/h,
FPM and knots by pressing "UNIT" button.

4.11 Air flow measurement

Before measurement, you must set the area of the air current at first, the de-
fault value is 1.0m2, press "SET" button enter area setting, one may press
"UNIT" button to select which digit of the area to change and press "HOLD"
button and "B.L" button to change the selection to be a suitability value that you
need, at last you may press "SET" button to save the setting.
The next place the sensor probe of anemometer in the tested environment and
to be sure the fan is in a uprightness position face to the air current and than
press the "ANEMO" button to measure. When the meter was first power on,
the default units setting is set at CMM scale. The user may change it to CFM
by pressing "UNIT" button, and than setting the area again.
Note:
While measuring the Wind speed and the Air flow, Avoid direct sunlight.

4.12 Battery replacement

If the sign " " appears on the LCD display, it indicates that the battery should
be replaced. Turn the unit off. Remove the battery cover. Replace the exhaust-
ed battery with a new one. Put the battery cover as its origin.
4.13 Use the tripod connector
If needed, the meter can be fixed on the tripod. The meter also can be hanged
up for use.
5. ACCESSORIES
• Battery 9V 6F22:
• Windbreak:
• Operating Manual:
• Sensor Probe Holder:
KPS-MF50 • Enviromental tester
One piece
One piece
One piece
One piece
20