Black and Decker BCD701 Manual De Instrucciones página 9

OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the GoPak 2 in 1
Battery in a Power Tool (Fig. F)

WARNING: Remove any connected USB cords from
the BLACK+DECKER GoPak 2 in 1 battery before
connecting the GoPak to the compatible tool.
1. Remove the tool terminal cap if installed on the
BLACK+DECKER GoPak 2 in 1 battery.
2. Make certain the fwd/rev button is in the center, lock-
off position before removing or installing the battery.
3. To power a compatible GoPak 12V MAX* power tool,
align the tool terminals on the foot of the tool with the
terminal slots on the battery
nOTE: The state of charge indicator will face the rear of
the tool and the USB ports will face the front. The arrow on
the battery will align with the arrow on the tool as shown
in Fig. F.
4. Snap the BLACK+DECKER GoPak 2 in 1 battery into the
foot of the tool. The arrow
with the arrow 15 on the tool. Ensure the battery is
fully seated and fully latched into position before using.
5. To remove the BLACK+DECKER GoPak 2 in 1 battery
from the tool, depress the two battery release buttons
located on the tool and pull the BLACK+DECKER
7
GoPak 2 in 1 battery off the tool.
nOTE: The BLACK+DECKER GoPak 2 in 1 battery USB ports
are disabled when the trigger is pulled.
Fig. F
15
8
6
Using the GoPak 2 in 1 battery to
charge your USB device (Fig. G)
1. Plug the USB A end of your device specific cable
into the BLACK+DECKER GoPak 2 in 1 battery
and the other end of the cable into a UL or CSA listed
compatible device (Phone/Tablet/MP3/Wearable/Game
Controller/etc.). Charging will start automatically.
6 as shown in Fig. F.
8 on the battery will align
7
14
11
Fig. G
14
Functionality
The BLACK+DECKER GoPak 2 in 1 battery can power your
compatible BLACK+DECKER 12V GoPak MAX* tools or
power/charge your mobile devices. The compact, slim
battery housing is designed for portability.
- GoPak Charge Input: Up to 2.4A**
- GoPak Power Output: Up to 2.4A***
** Actual input charge rate is dependant upon power
adapter (not included).
***Actual output rate is dependant on the device.
USB Power Port
The BLACK+DECKER GoPak 2 in 1 battery is equipped with a
USB Type A power port. It delivers up to 2.4 amp total current.
nOTE: The current delivered to device is dependent on user
device and user's chosen cable.

WARNING: Ensure the terminal cap is securly
attached to the BLACK+DECKER GoPak 2 in 1 battery
when using it to power/charge your device.
• Install terminal cap on the tool terminals.
• Device charging from USB will start automatically when
device is connected.
• To turn OFF, disconnect USB device.
Proper Hand Position (Fig. H)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
and one hand around the battery.
Fig. H
English
11
7