High Dumping System - Columbus AKS 70 BM 62 Manual De Instrucciones

Ocultar thumbs Ver también para AKS 70 BM 62:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Vacuum sweeper
AKS 70|BM 62
The machine battery is not performing
properly. The machine is slow and does
not clean well
CHAPTER 19 - WARRANTY
This machine is guaranteed against defects in workmanship or installation for 12 months from the date of sale.
The warranty covers exclusively the replacement or repair parts that are defective. Any other request will not be accepted.
This does not include damage caused by normal wear, use different from that reported on this manual, damage caused by wrong settings,
technical operations not carried out properly, act of vandalism.

HIGH DUMPING SYSTEM

The electric high dumping system of the waste container (
Introduction: to unloading, you must insert the parking brake, get out of the sweeper without turning off the ignition key (Part. 1 Fig. 2),
release the hooks (Part. G Fig. 1).
1)
To start the lifting of the container, put the switch Part. 1 Fig. 3 back.
2)
Begin the lifting. Fig. 4+ 5
3)
IMPORTANT: be careful that nothing prevents the complete release of the two supporting legs of the machine (Fig. 6), or the lifting
of the container will stop.
4)
IMPORTANT: if the sweeper is switched off or if it was a power failure, to restart the unloading of the container you have to start the
sweeper and misfire the safety switch Part. 1 Fig. 7.
5)
Reached the desired height of the container (max 110 cm), you can wrap it with a big bag for waste. Fig. 8
6)
Sequence of emptying of the dust container. Always keep with a hand the handle of the waste container.
7)
Push the knob (Part. R Fig. 9) down and turn counter-clockwise with one hand keeping the handle of the container also.
8)
Now release the dust container by turning the knob (Fig. 9, 10, 11), empty the container into the bag (Fig. 12), put it back removing
the bag and turn the knob to lock it again (Fig. 14, 15).
9)
To start the descent of the dust container, pull the lever forward Part. 1 Fig. 16.
10) When the cylinder has finished its run, take the dust container's handle (Part. 1 Fig. 19) with an hand and push with one foot on the
pedal (Part. 2 Fig. 19).
11) When the container arrives at the bottom, close the two hooks (Fig. 20).
Battery flat or not completely charged
The battery charter is not that
recommended or is not enough
all pictures from page 71 onwards)
30
Check the level of the electrolyte and
procede with complete new charge cycle
Use a proper battery charger

Publicidad

Tabla de contenido
loading

Tabla de contenido