Technical Service - Campbell Hausfeld TL146200AJ Manual Del Operador

Operating Instructions
Maintenance
Release all pressure before
attempting to install, service,
relocate or perform any maintenance on
the air system. personal injury COULD
occur.
luBrIcatIon after each use
1. Add 3 to 5 drops of oil at the air inlet
(see Figure 14).
2. Attach air hose. Quickly pull the
trigger several times to leave residual
oil in motor.
storage
The tool motor muSt Be lightly
lubricated before storing.
Store in a cool, dry place.

technIcal servIce

For information regarding the operation
or repair of this product, please call
1-800-543-6400.
General Troubleshooting Guide
COULD result in death or serious injury.
Symptom
Tool runs slowly or
will not operate
12
Disconnect the air tool from the air supply bEfORE
servicing. failure to disconnect the air supply from the tool
possible cause(s)
1. Grit or gum in tool
2. No oil in tool
3. Low air pressure
4. Air hose leaks
www.campbellhausfeld.com
Oil (not
included)
Figure 14 - lubricate the air motor
corrective Action
1. Flush the tool with Campbell Hausfeld air
tool oil, gum solvent, or SAE 10 motor oil. If
Campbell Hausfeld oil is not used, lubricate the
tool after cleaning
2. Lubricate the tool according to the lubrication
instructions in this manual
3. Adjust the compressor regulator to 90 psi
maximum while the tool is being triggered
4. Tighten and seal hose fittings if leaks are found
Air Inlet