Scrapping - Clarke Vantage 13 Libro De Instrucciones

ENGLISH
TROUBLESHOOTING
Trouble
The motors do not turn on.
Dirty water vacuuming is insuffi cient or there is
no vacuuming.
The solution fl ow is insuffi cient.
The brushes do not turn.
The squeegee leaves marks on the fl oor.
The fl oor is wet with dirty water.
(*) This maintenance procedure must be performed by Clarke authorized Service Center.
For further information refer to the Service Manual, available at any Clarke Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force (local guidelines):
– Brooms
– Electrical and electronic components (*)
(*) Refer to the nearest Clarke Center especially when scrapping electrical and electronic components.
18
Possible Cause
The power supply cable is faulty or
disconnected from the electrical mains.
The vacuum grid is clogged.
The vacuum hose is disconnected from the
deck or it is damaged.
The squeegees are dirty or the squeegee
blades are worn or damaged.
The gasket of the transparent cover is
damaged.
The vacuum system motor is faulty.
The solution fi lter is dirty.
The driving belt is loosened or broken.
The brush motor is damaged.
There are debris under the squeegee
blades.
The squeegee blades are worn, chipped or
torn.
The recovery tank is full and the excess of
dirty water is ejected.
Remedy
Replace the cable or connect it.
Clean.
Connect or replace.
Clean or replace the squeegees.
Check and/or clean the seating surface or
replace the gasket.
Replace (*).
Clean or replace.
Adjust or replace (*).
Replace (*).
Remove the debris.
Replace the blades.
Empty the tank.
Operator's Manual - Vantage 13