Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - Clarke Vantage 13 Libro De Instrucciones

ENGLISH

INTRODUCTION

NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.
Thank you for choosing a Clarke scrubber-dryer.
Clarke scrubber-dryer Vantage 13 is an effi cient and superior quality machine for fl oor cleaning.
The machine is equipped with two turning brushes for a cleaning width of 330 mm.
Front and rear squeegees clean out the fl oor, while a vacuum system collects the dirty water, all in one wipe.

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with all necessary information to use the machine properly in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualifi ed technicians must read this Manual carefully. Contact
Clarke in case of doubts concerning the interpretation of the instructions and for any further information.

TARGET

This Manual is intended for operators and technicians qualifi ed to perform the machine maintenance.
The operators must not perform procedures reserved for qualifi ed technicians. Clarke will not be answerable for damages coming
from the non-observance of this prohibition.

HOW TO KEEP THIS MANUAL

The Operator's Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that can
cause damage to it.

IDENTIFICATION DATA

The machine serial number and model are shown on the plate (1).
The machine production year is indicated by the fi rst two fi gures of the machine serial number.
This information is useful when requiring machine spare parts. Use the following table to write down the machine identifi cation data.
MACHINE model ...............................................................................
MACHINE serial number ...................................................................

OTHER REFERENCE MANUALS

– Spare Parts List (supplied with the machine)
– Service Manual (that can be consulted at any Clarke Service Center)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures must be performed by qualifi ed personnel or by Clarke Service
Centers. Only original spare parts and accessories must be used.
Call Clarke for service or to order spare parts and accessories, specifying the machine model and serial number.

CHANGES AND IMPROVEMENTS

Clarke constantly improves its products and reserves the right to make changes and improvements at its discretion without being
obliged to apply such benefi ts to the machines that were previously sold.
Any change and/or addition of accessory must be approved and performed by Clarke.
2 Operator's Manual - Vantage 13