Connecting The Tattooing Machine; Using The Power Unit; Disinfecting The Power Unit; Setting The Piercing Frequency - Cheyenne POWER UNIT I Instrucciones De Uso

Switching on PU II:
 Switch the On/Off switch to the
"I" position.
The preset piercing frequency of
110 pierces per second appears on the
display.
5.5

Connecting the tattooing machine

 Ensure that Power Unit is switched on.
PU I:
 Plug the jack plug of the
connecting cable for tattooing
machine completely into the
jack for the tattooing machine.
PU II:
 Plug the jack plug of the connect-
ing cable for tattooing machine 1
completely into the jack for the tattooing
machine 1.
 To alternate between two tattoo-
ing machines, plug the jack plug
of the connecting cable for tattooing
machine 2 completely into the jack for
the tattooing machine 2.
24 EN
6

Using the Power Unit

6.1

Disinfecting the Power Unit

ATTENTION
Damage caused by fluid
If cleansers or disinfectants enter the
Power Unit of the power supply plug or
their jacks or plugs, a short-circuit can
occur.
 Never immerse the Power Unit or
TATTOO-
power supply plug in cleansers or
MACHINE
disinfectants.
ATTENTION
Product damage caused by
non-approved disinfectants
Disinfectants that are not compatible
with the materials of the Power Unit can
damage its surface.
 Always use disinfectants that are ap-
proved, i.e. that comply with stipula-
tions in your country.
 Observe and check to ensure material
compatibility (see chapter 7.1 on page 26).
 Disconnect the Power Unit from the
voltage supply by pulling the power
supply plug out of the socket.
 Check to determine whether there is
visible soiling of the Power Unit. In such
cases, perform the steps described in
chapter "7 Cleaning and maintaining
the Power Unit" on page 26.
 Wipe down the Power Unit, the power
supply plug and the connecting cable
with a soft cloth moistened with disin-
fectant.
 Cover the Power Unit with a plastic
sheet.
6.2

Setting the piercing frequency

CAUTION
Risk of injury due to high piercing
frequency
If the piercing frequency is too high, the
skin can be cut.
 Always start at a low piercing frequen-
cy, e.g. 70.
 Please observe that the piercing
frequency must suit the characteristics
of the customer's skin, the needle
protrusion and the individual piercing
depth when working, as well as the
operating speed.
Cheyenne Power Unit I & Power Unit II