Disinfecting Surfaces; Cleaning Surfaces; Transport And Storage Conditions; Disposal Of Equipment - Cheyenne POWER UNIT I Instrucciones De Uso

7.2

Disinfecting surfaces

Before and after each usage:
 Disinfect all surfaces of the Power Unit
as described in chapter 6.1 on page 24.
7.3

Cleaning surfaces

In the event of external contamination:
 Wipe the Power Unit, the power supply
plug and the cable with a soft cloth
moistened in a cleaning agent or
a disinfectant.
8 Transport and storage
conditions
ATTENTION
Damage to product caused by dropping
it
If the Power Unit is dropped, it can be
damaged.
 Always place the Power Unit on its
rubber feet on a level and stable
surface so that it cannot fall.
 If the Power Unit falls, perform a visual
inspection of the components.
Cheyenne Power Unit I & Power Unit II
 Hand
over the Power
a specialist retailer for inspection if it
exhibits any external signs of damage
or if it does not function in the normal
manner.
 Always transport the Power Unit and its
accessories in their original packaging.
 Always store the Power Unit and
its accessories under the following
conditions:
Ambient -40 to +40 °C
temperature -40 to +104 °F
relative
30 to 75%
humidity
Air pressure 700 to 1070 hPa
9

Disposal of equipment

 Dispose of the Power Unit and
accessories bearing the following
designation in accordance with
the applicable regulations for used
electronic equipment. If necessary,
consult the specialist retailer or the
responsible authorities to learn about
applicable regulations.
10

For questions or problems

Unit to
10.1 Risk of injury when lifting the
tattooing machine
If the connected tattooing machine does
not start, although the Operating LED is
illuminated:
 Only PU II: Ensure that desired tattooing
machine is activated (see chapter 6.4 on
page 25).
 Test the function of the tattooing ma-
chine as described in the corresponding
operating instructions.
If the connected tattooing machine does
not start and the Operating LED is not
illuminated:
 Perform all steps described in chapter
10.2 below.
10.2 Correcting Power Unit
malfunctions
 Disconnect the Power Unit from the
voltage supply, from the optional foot
switch and from the tattooing machines.
 Check all connections and re-connect
the components.
 Check the functions of the Power Unit
once again.
EN 27