Rockwell Automation Allen Bradley InView Serie Manual De Instalación página 8

3. Use two 10-32 x 1/4 Phillips screws (supplied) to secure the wall
Phillips
screws go
here.
4. Replace the end cap using the 4 screws removed in Step 1
5. Repeat Steps 1 to 4 for the other end of the sign. Distances
Fasten
these
screws.
6. Attach the two remaining wall mounting brackets to a wall so
7. Connect the mounting brackets on each end of the sign together
mounting bracket to the back of the sign. Torque the screws to
2.7 Nm (24 in-lb).
above. Torque the screws to 2.7 Nm (24 in-lb).
between the bracket holes, center-to-center, should be
approximately:
37 in (94 cm) for 2706-P42 and
72.2 in (183 cm) for 2706-P43
that they align with the brackets on the sign.
Do NOT install the sign directly to drywall or
TIP
plaster-board. The sign must be fastened to a wall
capable of supporting at least four times the weight
of the sign.
using a 5/16 Phillips screw and a 5/16 washer through the
mounting holes, as shown below, securing with a 5/16 nut. Do
not tighten the nut at this time.
Side view
Screw and
washer through
mounting holes
InView Marquee Message Display
Top view
Mounting
holes
Nut Brackets Washer Screw
Publication 2706-IN006E-EN-P
7