Time/Date Settings; Preparations For Measurement; Commissioning - Trotec SL 300 Manual De Instrucciones

04. TIME/DATE SETTINGS

-. Press.the.A/C.button.and.switch.the.appliance.on . . Re-.
. lease.the.A/C.button.as.soon.as.the.abbreviation."SET". .
. appears.on.the.display . . The.appli-.
. ance. is. now. in. calibration. mode . . .
. The.date.is.shown.on.the.display.as. .
. follows:.DATE.28 . 0 8 . 2 00
-. Press. the. A/C. button. a. second. .
. time. to. display. the. time:. TIME. .
. 16:58:18
-.Press.the.A/C.button.a.third.time. .
. to.set.the.minutes.(shown.on.the. .
. display.as.--.xx-1.)
-.Press. the. A/C. button. a. fourth. .
. time.to.set.the.hours.(shown.on. .
. the.display.as.--.xx-2.)
-.Press.the.A/C.button.a.fifth.time. .
. to. set. the. date. (shown. on. the. .
. display.as.--.xx-3.)
-.Press.the.A/C.button.a.sixth.time. .
. to.set.the.month.(shown.on.the. .
. display.as.--.xx-4.)
-.Press. the. A/C. button. a. seventh. .
. time. to. set. the. year. (shown. on. .
. the.display.as.--.xx-5.)
-.Press. the. A/C. button. for. the. .
. eighth. time. -. rSt-6. -. reset. ap-.
. pears.on.the.display
To.save.the.changes.that.you.have.made,.you.must.
(!!!).press.the.A/C.button.again;.This.returns.you.to.the.
date.display . . Press.the.hold.button . . The.changes.that.
you.made.have.been.saved .
B - 3
OPERATING INSTRUCTIONS – SOUND LEVEL METER SL300
If.a.flat.battery.has.been.replaced.and.the.time.cannot.
be.set,.the.time.measurement.chip.must.be.initialised.
beforehand . .
Depending.on.which.section.of.the.menu.you.are.in,.
the.value.can.be.increased.with.the.Level.button.and.
decreased.with.the.Max/Min.button . . Note:.the.chan-
ges.you.make.are.always.saved.if.the.hold.button.is.
pressed.in.the.modes.--xx-1.to.xx---5 . . Conversely,.if.
you.press.the.hold.button.when.you.are.in.the.menu.
section.rSt-6.-.reset,.then.the.time.and.date.are.reset.
to.the.factory.settings . . In.each.case.the.appliance.is.
placed.in.measurement.standby.mode.after.pressing.
the.hold.button .

05. PREPARATIONS FOR MEASUREMENT

01 . . Remove.the.lid.from.the.battery.compartment.on. .
. the.back.of.the.appliance.and.insert.a.9V.battery .
02 . . Replace.the.lid.on.the.battery.compartment .
03 . . The. . . . . . . . . . . symbol.appears.on.the.display.as.soon.as.
- +
. the.battery.is.too.weak.and.the.voltage.falls.below.the. .
. operating.voltage . . In.this.case,.insert.a.new.battery .

06. COMMISSIONING

01 . . Switch.the.appliance.on .
02 . . Press.the.Level.button.to.set.the.desired.level . . The. .
. words."UNDER".or."OVER".do.not.appear.on.the. .
. display .
03 . . Select. dBA. to. measure. the. general. sound. level. .
. and.dBC.to.measure.acoustic.material .
04 . . Select. "FAST". for. a. fast. response. time. and. .
. "SLOW".to.display.the.average.sound.level .
05 . . Select.MAX/MIN.to.measure.the.maximum.or.mi-.
. nimum.noise.level.respectively .
06 . . Measurements.are.performed.from.a.distance.of. .
. 1.m.to.1 .50.m . . The.appliance.can.be.used.hand-.
. held.or.mounted.on.a.tripod .
G