Time Base- Voltage Scale Selection - Tecnotest SL31205 Manual Operativo


OSCILLOSCOPE KIT _______________________________________________________________________
b. MENU:
Setup: display of a control panel where to set the time base and the voltage
scale, both for the PRIMARY or SECONDARY (present only on SL31205/PLUS)
and for each low voltage signal.
Measure: display of the CURSOR SELECTION pull-down menu where the
red or the blue cursor to be set on the display can be selected.
Trigger: display of the TRIGGER pull-down menu for the selection of
enabling or disabling and display of the EDGE SLOPE pull-down menu to
select either the rising edge or the falling edge.
Help: display of a diagnostics help and of an image indicating a quality
example referring to the selected typical.
•
To carry out the selections, use the cursor control keys and then press ENTER
to confirm the selection.
•
To leave from the control panel press either MENU or ESC.
4.1 - Time base– Voltage scale Selection
•
Push F3 to select SETUP and then push F1 to select the times base and the
voltage scale.
•
Through the upward and downward cursor control keys set the voltage scale
(Volt) according to the needs.
•
Through the right - left cursor control keys set the time base (time/div).
NOTA BENE:
The values of the voltage scale and of the time base vary according to the set mode
(LAB SCOPE, PRIMARY or SECONDARY).
46 OPERATING INSTRUCTIONS