Meter Description - Southwire 10010S Instrucciones De Uso

International Safety Symbols
Potential danger. Indicates the user must refer to the
manual for important safety information
Indicates hazardous voltages may be present
Equipment is protected by double or reinforced insulation
MAX
Indicates the terminal(s) so marked must not be connected
500V
to a circuit where the voltage with respect to earth ground
exceeds the maximum safety rating of the meter
Indicates the terminal(s) so marked may be
subjected to hazardous voltages.
Safety Category Ratings
Category
Brief Description
Rating
Protected electronic
CAT I
equipment
CAT II Single phase receptacles
and connected loads
The measurement category (CAT) rating and voltage rating is determined by a combination of the meter,
test probes and any accessories connected to the meter and test probes.
The combination rating is the LOWEST of any individual component.
Typical Applications
- Low energy circuits that are designed to limit
transient over-voltages
- Household appliances, power tools
- Outlets more than 30ft (10m) from a CAT III source
- Outlets more than 60ft (20m) from a CAT IV source
3
Maintenance
This Multimeter is designed to provide years of dependable service,
if the following care instructions are performed:
1. KEEP THE METER DRY. If it gets wet, wipe it off.
2. USE AND STORE THE METER IN NORMAL TEMPERATURES. Temperature
extremes can shorten the life of the electronic parts and distort or melt
plastic parts.
3. HANDLE THE METER GENTLY AND CAREFULLY. Dropping it can damage the
electronic parts or the case.
4. KEEP THE METER CLEAN. Wipe the case occasionally with a damp cloth.
DO NOT use chemicals, cleaning solvents, or detergents.
5. USE ONLY FRESH BATTERIES OF THE RECOMMENDED SIZE AND TYPE.
Remove old or weak batteries so they do not leak and damage the unit.
6. IF THE METER IS TO BE STORED FOR A LONG PERIOD OF TIME, the batteries
should be removed to prevent damage to the unit.

Meter Description

1. Meter display
2. Ohms adjust
3. Rotary Function switch
4. Positive input jack
5. Negative input jack
NOTE: The meter does not have
an OFF button. No power from
the battery is consumed when
not in use.
NOTE: Test leads include probe tip
covers that must be removed to
take measurements.
1.
3.
4
2.
4.
5.