Standard Accessories; Maintenance And Inspection - HIKOKI D 10VC3 Instrucciones De Manejo

English

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed in the below.
(1) Chuck wrench (Spec. only for keyed chuck) ................1
Standard accessories are subject to change without notice.
SPECIFICATIONS
Voltage (by areas)*
Power input
No load speed
Drill chuck capacity
Steel
Capacity
Wood
Weight (without cord)
Spec. for keyed chuck
Spec. for keyless chuck
* Be sure to check the nameplate on product as it is subject to change by areas.
MOUNTING AND OPERATION
Action
Fixing and removing side handle
Mounting and dismounting the bit
Selecting rotational direction
Switch operation
Locking-on the switch
Releasing the switch
Adjusting the trigger switch pull
distance
Mounting position of hook
(Optional accessory)
Mounting position of hook (A)*
(Optional accessory)
Selecting accessories
*1 Attaching the hook (A). (Optional accessory)
To attach the hook (A), it is necessary to disassemble
the handle portion which covered the tool's electrical
system. For your continued safety and electrical shock
protection, installing the hook (A) on this drill should
ONLY be performed by a HiKOKI AUTHORIZED
SERVICE CENTER.
Selecting the appropriate drill bit
○ When boring metal or plastic
Use ordinary metalworking drill bits.
○ When boring wood
Use ordinary woodworking drill bits.
However, when drilling 6.5 mm or smaller holes, use a
metalworking drill bit.
Twist Bit
Flat Spade Bit
Auger Bit
Figure Page
1 86
2 86
3 86
4 86
5 87
6 87
7 87
8 87
1
9 87
― 88
APPLICATIONS
Drilling in metal, lumber and plastics.
(110 V, 220 V, 230 V, 240 V)
600 W*
0 – 2500 min
10 mm
10 mm
32 mm
25 mm
1.4 kg
1.4 kg

MAINTENANCE AND INSPECTION

1. Inspecting the drill bits
Since use of an abraded drill bits will cause motor
malfunctioning and degraded effi ciency, replace the drill
bits with a new one or resharpening without delay when
abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Inspecting the carbon brushes
For your continued safety and electrical shock protection,
carbon brush inspection and replacement on this tool
should ONLY be performed by a HiKOKI Authorized
Service Center.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
GUARANTEE
We guarantee HiKOKI power tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the power tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling instruction,
to a HiKOKI Authorized Service Center.
4
–1