Caution On Lithium-Ion Battery - HIKOKI С 18DMR Instrucciones De Manejo

English
NEVER place your hand or fingers behind the saw
(Fig. 3). If kickback occurs, the saw could easily
jump backwards over your hand, possibly causing
severe injury.
30. WARNING: It is important to support the work
piece properly and to hold the saw firmly to
prevent loss of control which could cause personal
injury. Fig. 4 illustrates typical hand support of the
saw.
31. Place the wider portion of the saw base on that
part of the work piece which is solidly supported,
not on the section that will fall off when the cut
is made. As examples, Fig. 5 illustrates the RIGHT
way to cut off the end of board, and Fig. 6 the
WRONG way. If the work piece is short or small,
clamp is down.
DON'T TRY TO HOLD SHORT PLACES BY HAND!
32. Never attempt to saw with the circular saw held
upside down in a vise. This is extremely dangerous
and can lead to serious accidents (Fig. 7).
33. When the brake becomes ineffective, replace the
carbon brushes with new ones.
SPECIFICATIONS
Power Tool
Model
No-load speed
Capacity Cutting depth
Rechargeable 18 V 2.0 Ah
battery 18 V 2.6 Ah
18 V 3.0 Ah
18 V 3.0 Ah
18 V 3.3 Ah
Light bulb
Weight
Charger
Model
Charging voltage
Charging time
Weight
Charge time is approximate. Actual charge time may vary.
"x" Indicates that the battery pack is not compatible with that specific charger.
11
90°
45°
EB1820L: Ni-Cd (15 cells)
EB1826HL: Ni-MH (15 cells)
EB1830HL: Ni-MH (15 cells)
EB1830X: Ni-MH (15 cells)
EB1833X: Ni-MH (15 cells)
2.0 Ah : Ni-Cd
2.6 Ah : Ni-MH
3.0 Ah : Ni-MH
3.3 Ah : Ni-MH
3.0 Ah : Li-ion

CAUTION ON LITHIUM-ION BATTERY

To extend the lifetime, the lithium-ion battery equips
with the protection function to stop the output.
In the cases of 1 and 2 described below, when using
this product, even if you are pulling the switch, the
motor may stop. This is not the trouble but the result
of protection function.
1. When the battery power remaining runs out (The
battery voltage drops to about 12V (C18DL)), the
motor stops.
In such case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In
this case, release the switch of tool and eliminate
causes of overloading. After that, you can use it
again.
C18DMR
3400 min
57 mm
40 mm
12 V, 5 W
3.6 kg
UC24YFA UC18YG
7.2 – 24 V 7.2 – 18 V
50 min. 50 min.
65 min.
70 min.
75 min.
x
0.6 Kg
C18DL
–1
x
x
EBM1830: Li-ion (10 cells)
x
x
3.2 kg
UC18YRL
7.2 – 18 V
30 min.
x 40 min.
x 45 min.
x 50 min.
x 45 min.
0.3 Kg 0.6 Kg