Publicidad
Idiomas disponibles
Idiomas disponibles
A c c e s s o r i e s
S t e m D e f l e c t o r
The stem deflector is a very simple alternative to the standard stem
collector and allows access in restricted areas. To replace the stem
collector with the stem deflector proceed as follows:
•
Unscrew retaining nut 21 by inserting a 3 millimetre diameter rod
into one of the holes.
•
Remove retaining nut 21 and the stem collector assembly, items
15, 16, 17, 18, 19, and 20.
•
Screw the adaptor nut onto end cap 22.
•
Push the boss end of the stem deflector into the internal groove
of the adaptor nut.
•
Rotate the stem deflector until the aperture faces away from the
operator and other person(s) in the vicinity.
E x t e n s i o n
Fitted between the tool and the nose assembly the extension allows
access into deep channels.
•
To fit the extension, remove any nose assembly components.
•
Screw the inner extension to jaw spreader housing 1.
•
Screw the outer onto head assembly 4.
•
Fit the nose assembly onto the extension.
S i d e E j e c t o r
Fitted between the tool and the nose assembly, the side ejector
forces fastener stems to eject at the front of the tool and reaches
into deep channels.
It cannot be used in conjunction to a swivel head. Select the correct
part number (below right) according to the stem diameter of the
fastener.
For greater ease of use, it is recommended that the stem collector
or deflector is replaced with safety cap part number 71210-20201
as used with swivel heads. See page 14 for fitting instructions, but
note that the stop nut is not fitted in this case.
•
To fit the side ejector, remove any nose assembly components.
•
Remove the socket cap screw from the side ejector.
•
Screw the inner extension onto jaw spreader housing 1.
•
Screw the outer casing onto head assembly 4.
•
Replace the socket cap screw securing with Loctite Screwlock
222, part number 07900-00371.
•
Screw the nose assembly onto the side ejector.
Item numbers in bold refer to the general assembly drawing and parts list on pages 22-23.
STEM DEFLECTOR
ADAPTOR NUT
71210-20101
STEM DEFLECTOR: 71210-20100
INNER
71210-20301
EXTENSION PART NUMBER: 71210-20300
Part number: 07498-00900
for fasteners with a stem larger than 3.1 mm (
OUTER CASING
INNER
EXTENSION
E n g l i s h
07340-00342
OUTER
71210-20302
1
/
") Ø
8
8-32 x
1
/
" SOCKET
4
CAP HEAD SCREW
11
Publicidad
