Description; Safety - Vortice VORT NOTUS Manual De Instrucciones

ENGLISH

Description

Appliances belonging to the VORT NOTUS range are
as follows:
VORT NOTUS
VORT NOTUS T-HCS
These appliances are axial extractor fans that have
been specially designed to provide continuous
ventilation in domestic applications whilst at the same
time reducing power consumption and noise
emissions.
The appliances are
installation (Vort Notus only) as well as with wall and
ceiling mounting and are fitted with axial blades
powered by a brushless motor. There are three
differing fan speeds available. The default minimum
speed can be one of two speeds that can be selected
during installation whereas the third speed can be
selected while the appliance is running (see
"Installation").

Safety

Warning:
!
this symbol indicates that care must
be taken to avoid injury to the user
• Do not use this appliance for functions other than
those described in this booklet
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician
or Vortice. Do not leave packaging within the reach
of children or infirm persons
• Certain fundamental rules must be observed when
using any electrical appliance, including:
- never touch electrical appliances with wet or
damp hands;
- never touch appliances while barefoot;
- never allow children or infirm persons to operate
appliances unattended.
• This appliance is not suitable for use by children or
by individuals with reduced physical, sensorial or
mental capacities, or by inexperienced or untrained
individuals, unless they are supervised or instructed
in its use by a person responsible for their safety
Children must always be supervised to ensure that
they do not play with the appliance.
• Store the appliance out of the reach of children and
less able persons after deciding to disconnect it
from the power supply and use it no more.
• Do not use the appliance where flammable vapours
are present (spirit, insecticides, petrol, etc.).
• Never touch the electronics as some of the
components may still be electrically charged.
•The appliance can also be ceiling mounted. For
ceiling mounting, the IPX4 rated protection against
humidity can be guaranteed by keeping the frontal
panel in position and using the special seal. Be
careful not to ceiling mount the appliance without
first fitting the special seal.
compatible with ducted
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Regularly inspect the appliance for visible defects. If
the appliance does not function correctly, do not
use it and contact Vortice immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice immediately and
ensure that only genuine original Vortice spares are
used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice
• The appliance must be installed by a professionally
qualified electrician
• The mains power supply to which the units are
connected must comply with current laws.
• The appliance is double insulated and therefore
does not need to be earthed
• The electrical power supply/socket to which the
appliance is to be connected must be able to
provide the maximum electrical power required by
the appliance
• Use a suitably sized multi-polar switch with
minimum contact gaps of 3 mm to install the
appliance.
• Switch off the appliance at the installation's main
switch: a) if the appliance does not function
correctly; b) before cleaning the outside of the
appliance, c) if the appliance is not to be used for
any length of time.
• The appliance cannot be used to control activation
of water heaters, room heaters, etc. and it must not
exhaust into the hot air flues.
• The air to be extracted from the room must be clean
(i.e. free of grease, soot, chemical and corrosive
agents, and explosive or flammable mixtures).
• Do not cover or block appliance intake or outlet
vents grilles as this may prevent optimum air flow.
• VORT NOTUS T-HCS model: do not cover or block
the HCS sensor grille.
• Specifications for
correspond to the electrical data on data plate A
(Fig.1)
• The power cable must never be replaced/repaired
by the user, but only by a qualified electrician
the power supply must
7