Checking The Chain Brake; Startup; Operation - Stiga CS 80 Li Manual De Instrucciones

Motosierra de cadena alimentada por batería portátil
Ocultar thumbs Ver también para CS 80 Li:
Tabla de contenido

Publicidad

Guards
Battery
Machine
Throttle control
lever, safety button
Test driving
6.2.2 Machine operating test
Action
Fit the battery inside
its housing (par. 7.2.3).
Press the safety
button.
Activate the throttle
control lever. (without
pressing the throttle
lock button)
Press the throttle
lock button and
throttle control lever.
Release the throttle
control lever or press
the safety button.
CHECKING THE
CHAIN BRAKE
1. Start the machine
(par. 6.3 )
2. Grasp the
handgrips firmly
with both hands.
3. Use the throttle
lever to keep the
chain moving,
push the front hand
guard forwards
using the back
of your left hand
(par. 5.4 ).
If any of the results fails to
match the indications provided in
Intact, undamaged.
No damage to
the casing, no
liquid leakage
No signs of
damage or wear
The levers must
move freely and
not be forced.
No abnormal
vibrations.
No abnormal sound
Result
The green light must
come on (electric
circuit activated)
and the chain
must not move
The throttle control
lever remains blocked.
The levers must
move freely and
not be forced. The
chain moves.
The lever
automatically and
rapidly returns to
the idle position.
The chain should stop.
3. The chain must
stop moving
immediately.
When the chain has
stopped, immediately
release the throttle
control lever and
disengage the chain
brake (par. 5.4).
the tables, do not use the machine!
Contact a service centre to have it
checked and repaired if necessary.

6.3 STARTUP

1. Remove the protective bar cover (fig. 1.J).
2. Make sure the bar and the chain are not
touching the ground or any other object.
3. Fit the battery inside its housing
correctly (par. 7.2.3).
4. Press the safety button (green light) (fig. 9.A)
5. Press the throttle lock button (fig. 10.B)
and throttle control lever. (fig. 10.B).

6.4 OPERATION

Before felling or delimbing for
the first time, make sure:
– you have been specifically trained
to use this type of equipment;
– you have carefully read the safety
regulations and user instructions
contained in this manual;
– you practise first on logs on the ground
or attached to trestles, in order to
get familiar with the machine and the
most suitable cutting techniques.
To operate with the machine
proceed as described below:
• Always disengage the chain brake, pulling the
lever towards you before using the throttle.
• The machine must always be firmly held in
both hands, with the left hand on the front
handgrip and the right hand on the rear
handgrip, even if the operator is left-handed.
Stop the machine immediately
if the chain stops during sawing.
NOTE During use, the battery is
protected against total drainage with a
protective device that switches off the
machine and stops it from working.
6.4.1 Checks to be conducted
whilst working
6.4.1.a Checking the chain tension
The chain tends to stretch gradually
as you work, so you need to check its
tension frequently (par. 6.1.3).
6.4.1.b Checking the oil delivery
IMPORTANT Never use the
machine without lubrication!
EN - 9

Publicidad

Tabla de contenido
loading

Tabla de contenido