Cleaning And Maintenance; Technical Specifications - HQ-Power VDPLW1028W Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

DMX-512 Chain with Termination
DMX Start Address Selection
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This start address is the channel number from which the device starts to "listen" to the DMX
controller. Enter the correct number and read it from the display located on the base of the
VDPLW1028W.
You can use the same starting address for a whole group of devices or enter an individual one for
every device.
When all devices have the same address, all the VDPLW1028Ws will "listen" to the control signal
on one particular channel. In other words: changing the settings of one channel will affect all
devices simultaneously. If you set different addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
In the case of the 13-channel VDPLW1028W, you will have to set the start address of the first
VDPLW1028W to 1, the second VDPLW1028W to 14 (1 + 13), the third to 27 (14 + 13) and so
on.
6.

Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified or tampered with e.g. do not drill extra
holes in mounting supports, do not change the location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician
maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts apart from the fuse (see "Installation").
8. Contact your dealer for spare parts if necessary.
7.

Technical Specifications

Power Supply
Power Consumption
Fuse
LEDs
Dimensions
Total Weight
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.velleman.eu. The information in
this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman Components nv.
All worldwide rights reserved. No part of this manual or may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the prior written consent of the copyright
holder.
VDPLW1028W
A DMX terminator is recommended for installations where the DMX cable has
to run a long distance or is in an electrically noisy environment (e.g. discos).
The terminator prevents corruption of the digital control signal by electrical
noise. The DMX terminator is simply an XLR plug with a 120Ω resistor
between pins 2 and 3, which is then plugged into the XLR output socket of
the last device in the chain.
Please see illustrations.
max. 230VAC / 50Hz
max. 50W
2A, 250VAC (5 x 20mm) (order code FF2N)
252 pcs (10mm) (red: 108 pcs, blue: 72 pcs, green: 72 pcs)
1020 x 65 x 65mm
2.3kg
5
HQPOWER™

Publicidad

Tabla de contenido
loading

Tabla de contenido