Safety; Safety Instructions - Futurelight CC-200 Manual Del Usuario

FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY

1.1 Safety instructions

Every person involved with the installation, operation and maintenance of this device has to:
- be qualilfied
- follow the instructions of this manual
a dangerous electric shock when touching the wires!
This device has left our premises in absolutely perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this manual.
Important:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Always plug in the power plug least.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord.
This device falls under protection class I. Therefore it is essential to connect the yellow/green conductor to
earth.
The electric connection, repairs and servicing must be carried out by a qualified employee.
Do not connect this device to a dimmer pack.
Do not switch the fixture on and off in short intervals as the lamp is a cold restrike type and as this would
reduce the lamp's life.
During the initial start-up some smoke or smell may arise. This is a normal process and does not necessarily
mean that the device is defective.
Do not touch the device's housing bare-handed during its operation (housing becomes hot)!
For replacement use lamps and fuses of same type and rating only.
Keep this device away from rain and moisture!
Unplug mains lead before opening the housing!
BEFORE YOU INITIAL START - UP!
Caution ! Be careful with your operations.
With a dangerous voltage you can suffer
CAUTION!

1. Safety

22