Troy-Bilt TB25CB Manual Del Operador página 13

Cutting Head Shield
Cutting Head Shield
INSTALLING THE CUTTING HEAD SHIELD
(For straight-shaft units)
WARNING:
cutting head shield in place.
1. Remove the wing nut and washer from the cutting head shield.
2. Insert the short tab (the one without a hole) on the mount bracket into the slot on the cutting head
shield (Fig. 3).
3. Rotate the cutting head shield until the bolt on the cutting head shield protrudes through the hole
on the mount bracket (Fig. 3).
4. Place the washer onto the bolt (Fig. 4).
5. Screw the wing nut onto the bolt until the cutting head shield is firmly in place (Fig. 4).
Square Bolt
To prevent serious personal injury, never operate the unit without the
Slot
Fig. 1
Fig. 2
13
Mount Bracket
Mount Bracket
Wing Nut
Washer