Troy-Bilt TB25CB Manual Del Operador página 16

Desbrozadora
Ocultar thumbs Ver también para TB25CB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HANDLE ASSEMBLY
Follow the instructions that apply to the handle included with your unit. Refer to Installing and
Adjusting the Handle.
INSTALLING AND ADJUSTING THE HANDLE
(Handle Type A)
Installing the Handle
1. Push the handle down onto the upper shaft housing (Fig. 8). Make sure the hex bolt hole faces to
the left (Fig. 8).
2. Insert the bolt into the hex bolt hole and push it through (Fig. 9). Place the washer onto the bolt
(Fig. 9). Screw the wing nut onto the bolt, but do not tighten the wing nut completely (Fig. 9) .
3. Hold the unit in the operating position (Fig. 15). Move the handle up or down the upper shaft
housing to a comfortable location (Fig. 9). Make sure the handle is positioned beyond the end of
the safety label (Fig. 9).
4. Tighten the wing nut until the handle is secure.
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the wing nut (Fig. 9).
2. Hold the unit in the operating position (Fig. 15). Move the handle up or down the upper shaft
housing to a comfortable location (Fig. 9). Make sure the handle is positioned beyond the end of
the safety label (Fig. 9).
3. Tighten the wing nut until the handle is secure.
Upper Shaft
Housing
Hex Bolt Hole
Fig. 8
16
Handle

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Tb25sb

Tabla de contenido