Maintenance Instructions - Sears Kenmore 11091942710 Instrucciones De Instalación

REVERSING DRYER DOOR SWING (OPTIONAL)
Reverse the strike
1.  U seasmallflat-bladescrewdrivertoremoveplugstrip
from the dryer door opening. Slide the head of the
screwdriver under the plugs, without scratching dryer
surface, and lift up strip.
2. Remove the strike using a Phillips screwdriver.
3. Insert strike on the opposite side.

MAINTENANCE INSTRUCTIONS

Clean lint screen before and after each cycle.
■
Removing accumulated lint:
■
From inside the dryer cabinet:
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done
byaqualifiedperson.
From the exhaust vent:
Lint should be removed every 2 years, or more often,
depending on dryer usage.
Keep area around dryer clear and free from combustible
■
materials,gasoline,andotherflammablevaporsandliquids.
Keep dryer area clear and free from items that would
■
obstructtheflowofcombustionandventilationair.
26
Reinstall the door
1. Partially insert the third screw from the top; then, slide the
hinge onto this screw while hooking the hinge into the front
panel hole. Reattach door to dryer front panel with the
remaining three screws.
2.  C heckforfingerprintsontheglass.Cleanifnecessary.
3. Close door and check that it latches securely.
If dryer does not operate, check the following:
Electrical supply is connected.
■
Circuit breaker is not tripped or house fuse is not blown.
■
Door is closed. Listen closely to hear the door switch activate.
■
Control is set up properly and display shows cycle time.
■
Cycleselectionbuttonhasbeenpushedfirmly.
■
 F orgasdryers,checkthatgassupplyshut-offvalvesareset
■
in open position.