Getting Started; Power Source - Daewoo International DSK-377 Manual De Instrucciones

Altavoz bluetooth karaoke
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
25. LED LIGHT
26. SPEAKER
27. FM ANTENNA JACK
28. AC SOCKET
29. VENTILATION HOLE
30. HANDLE

Getting Started

POWER SOURCE

This unit works with rechargeable lead-acid battery (the battery capacity 4000mAh). Fully
charge the unit (around 5 hours) before using the product for the rst time. The playback time
has about 2 hours after full charging. Unplug the AC Power cord from the AC socket to work
on the battery pack after fully charged. Plugging the AC Power cord while the battery pack
is attached initiates the charging of this battery, the charge LED indicator lights red during
charging, when the battery is fully charged the indicator will turn to green. When the unit is
with low battery, the LED indicator will ash in red.
Warning:
1. Do not change the battery, only high-quali ed personnel can perform this operation.
2. Disconnect the AC power cord after fully charge to avoid battery overcharge.
3. If the unit is out of battery, charge the unit for around half an hour before using.
OPERATION INSTRUCTIONS
BASIC FUNCTION
TURNING THE UNIT ON/OFF
Press the power ON/OFF button to switch the unit on/o .
NOTE: In USB/Bluetooth/AUX mode, when the unit is not providing the main function for
around 15 minutes, the unit will automatically switch into standby mode. Press the Function/
button again to turn on the unit again.
Please note that low volume setting in the audio source may be recognized as "no audio
signal", this will a ect the capability of signal detection from the device and can also originate
an automatic switch into standby mode. If this happens please reactive the audio signal
transmission or increase the volume setting on the audio source player in order to resume
playback.
Electrostatic Discharge hints: The unit may reset or many not reset to normal operation mode
due to electrostatic discharge, just switch if o and reconnect again.
SETTING THE FUNCTION MODES
To change the function modes, press the FUNCTION/
button repeatedly to choose USB/
BLUETOOTH/AUX/RADIO function.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido