Sleep Timer; External Equipment; Using The Auxiliary Input; Play Timer - Panasonic SC-AKX640 Manual Del Propietário

Sistema estéreo con reproductor de discos compactos
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Sleep timer

The sleep timer turns off the system after the set time.
Press [SLEEP] to select the setting (in minutes).
To cancel, select "OFF".
To check the remaining time
Press [SLEEP].
Note:
The remaining time is shown for a few seconds every
minute. "SLEEP 1" is always shown when only 1 minute
remains.
The play timer and sleep timer can be used together.
The sleep timer always comes first. Be sure not to set an
overlapping time.

Play timer

(Except for Bluetooth
®
, AUX 1 and AUX 2 source)
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] to select "TIMER ADJ".
2
Press [Y, U] to set the start time and then press
[OK].
3
Re-do step 2 to set the end time.
4
Press [Y, U] to select the source you want to play
and then press [OK].
To start the timer
1
Press [SETUP] to select "TIMER SET".
2
Press [Y, U] to select "PLAY ON" and then press
[OK].
"#" is shown.
To cancel, select "PLAY OFF".
The system must be turned off for the timer to
operate.
To check the setting
Press [SETUP] to select "TIMER ADJ" and then press
[OK].
In standby mode, press [DISPLAY] two times.
Note:
The timer starts at a low volume and increases gradually to
the preset level.
The timer comes on at the set time every day.
If you turn off the system and then turn on again while a
timer is in operation, the timer will not stop at the end time.

External equipment

Preparation
• Disconnect the AC power supply cord.
• Turn off all equipment and read the appropriate
operating instructions.
Note:
Components and cables are sold separately.

Using the auxiliary input

You can connect a VCR, DVD player etc., and listen to
the audio through this system.
Rear panel of this main unit
Audio cable
(not supplied)
1
Connect the external equipment.
2
Press [RADIO/AUX] to select "AUX 1".
3
Play the external equipment.
Note:
If you want to connect equipment other than those
mentioned, refer to the audio dealer.
Sound distortion can occur when you use an adapter.
DVD player (not supplied)
13

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido