Alarm Activation Period; Movement-Rate Warning - Snuza Go Manual De Instrucciones

This feature may be used with a baby sound monitor to enable you to 'hear'
baby's movements from a distance.

8.2 Alarm Activation Period

Decide whether you prefer the alarm to activate after 15, 18 or 20 seconds of
no movement.
Ensure that Snuza Go! is switched OFF.
Press and hold the MODE/OFF button (6) for 5 seconds until the unit beeps
and both indicator lights flash briefly.
The Movement Indicator Light (3) will then start flashing with a pause between
flashes. The following number of flashes relate to the alarm activation period:-
1 flash – 15 seconds
2 flashes – 18 seconds
3 flashes – 20 seconds
The factory pre-set value is for 20 seconds (3 flashes).
Each press of the ON/OFF button (5) will increase the number of flashes from
1 to 3. Press the ON/OFF button until the desired number of flashes (relating
to the desired setting) is reached. Press the MODE/OFF button (6) to store the
setting. Snuza will be in the power OFF mode after the setting has been saved.
If the settings mode is entered and no button presses are detected within 30
seconds, Snuza will switch to the monitoring mode (as if the unit had been
turned on using the ON/OFF button).

8.3 Movement-Rate Warning

The Movement-rate Warning alerts you if the baby moves less than 8 times
per minute – the Movement Indicator Light (3) flashes orange and the
Movement-rate Warning sounds (dual-tone beep every second). This feature
is automatically enabled each time Snuza is switched ON.
12