Basic Operation - Makita GB602 Manual De Instrucciones

Ocultar thumbs Ver también para GB602:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
2
Mount the work rests to the work rest bracket using the
two hex bolts.
Before tightening the bolts, adjust the gap between the
Grinding wheel and work rest to a maximum of 1.6 mm.
Tighten securely.

BASIC OPERATION

WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing dust.
If operation is dusty, wear a dust mask.
To be efficient and work as designed, your tools should be
kept sharp. Dull tools can and will cause accidents.
Bench Grinders are ideal for sharpening tools such as
chisels, planer blades, scissors, etc., and for removing
rust or corrosion.
WARNING:
Never sharpen or grind anything made of aluminum.
Grinders remove material rapidly so pressure is the key to
efficient grinding.
The proper way to sharpen a tool and avoid overheating
is:
■ Keep a tool on the work rest firmly at the correct the
wheel.
■ Keep the object in constant motion, moving it at an
even pace.
■ Never force a tool against the grinding wheel.
■ Keep the tool cool by using either a cooling tray, or a
pan of water.
■ The grinding wheel should rotate "into" the object being
sharpened.
NOTE:
Excessive pressure may damage the tool, cause the
motor to overheat, and prematurely wear down the
grinding wheel.
WARNING:
Excessive pressure on a cold wheel cause the wheel to
crack.
1. Work rest
bracket
2. Hex bolt
Fig. 7
OPERATION
GB602W only
1
2
Mount the blade work rest to the work rest bracket using
the two hex bolts.
Before tightening the bolts, adjust the gap between the
Grinding wheel and work rest to a maximum of 1.6 mm.
Tighten securely.
GB801 only
Balancing the grinding wheel
When the grinding wheel only is mounted, the heaviest
section will assume the lowest Position. Mark this section
as in the Fig. 9.
2
1
In this condition (Fig. 9) install the flange and balance
weight.
The balance weight should be positioned above as Seen
in the Fig. 10.
Then, temporarily tighten the flange with the installing nut.
1. Work rest
2. Hex bolt
Fig. 8
Fig. 9
1. Nut
2. Flange
3. Balance weight
3
Fig. 10
7

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Gb602wGb801

Tabla de contenido