Removing Pipe From The Machine; Inspecting Threads - RIDGID 300 Compact Manual De Instrucciones

Figure 25A – Oil Pump Connections for Left Hand
Threading (Switch in REV)
Figure 25B – Oil Pump Connections for Right Hand
Threading (Switch in FWD)
Figure 25C – Cover in Place
2. Place a 5 / " pin 2" long through the holes in carriage
16
rest and left hand die head to retain in place (see
Figure 26).
300 Compact/1233 Threading Machines
Pump In (REV)
From Filter
Figure 26 – Retaining LH Die Head in Place
Pump Out (FWD)
To Carriage

Removing Pipe from the Machine

Pump Out (FWD)

Inspecting Threads

From Filter
Pump In (REV)
To Carriage
Figure 27 – Checking Thread Size
Holes
Holes
1. With the REV/OFF/FWD switch in the OFF position
and the pipe stationary, use repeated and forceful
clockwise spins of the handwheel to loosen the pipe
in the chuck. Open the front chuck and the rear-cen-
tering device. Do not reach into chuck or centering
device.
2. Firmly grip the pipe and remove from the machine.
Carefully handle the pipe as the thread may still be hot
and there may be burrs or sharp edges.
1. After removing the pipe from the machine, clean the
thread.
2. Visually inspect thread. Threads should be smooth
and complete, with good form. If issues such as
thread tearing, waviness, thin threads, or pipe out-of-
roundness are found, the thread may not seal. Refer
to the Troubleshooting Chart for help in diagnosing
these issues.
3. Inspect the size of the thread.
• The preferred method of checking thread size is
with a ring gauge. There are various styles of ring
gauges, and their usage may differ from that shown
here.
• Screw ring gauge onto the thread hand tight.
• Look at how far the pipe end extends through the
ring gage. The end of the pipe should be flush with
the side of the gauge plus or minus one turn. If
thread does not gauge properly, cut off the thread,
adjust the die head and cut another thread. Using a
thread that does not gauge properly can cause
leaks.
Ring
Gauge
Flush
One Turn Large
(Basic Size)
(Maximum Size)
Pin Pin
One Turn Small
(Minimum Size)
15