Phonic i2600 Manual Del Usuario página 9

4 UTILITY MENU:......
<< Security Utilities >>
SECURITY UTILITY:
3.1
Show Parameter
SECURITY UTILITY:
3.2
Lock Unit
3.3 SECURITY UTILITY:
User Password
3.4 SECURITY UTILITY:
Enable Password
Input Channels Editing
By pushing either the A or B Input channel buttons and holding the buttons down for at least 2 seconds, you can access the different
parameters for their respective input channels.
NAV/PM1 Encoder
[to navigate between menus]
1. Input A/B Source
Source = Analog
-> Source = Analog
2. Input A/B Ngate
Noise Gate Byp = On
-> Noise Gate Byp = On
3. Input A/B Gain
Gain = + 0.0 dB
-> Gain = + 0.0 dB
4. Input A/B AGC
AGC Byp = On
-> AGC Byp = On
5. Input A/B Delay
Delay = 0.000 ms
-> Delay = 0.000 ms
i2600
ESC Parameter will
be shown
ENTER
not be shown
ESC Lock Unit
Lock: Off
ENTER
Lock: On
User Password
ESC
[ ]
ENTER
Enable Password
ESC
Password: Enable
ENTER
Password: Disable
NAV/PM1 Enc.
[to chose values for the parameters, no need to confirm the chosen values,
which are automatically loaded during the encoders use]
PM1 N/A
[The full editing of the Noise Gate parameters is available from Pc Sw Remote
Control;the desired setting can be stored in the unit and recalled when selected
"On" from the front panel, or deactivated when selected "Off"]
PM1 N/A
PM1 N/A
[The full editing of the Automatic Gain Controller parameters is available from
Pc Sw RemoteControl; the desired setting can be stored in the unit and recalled
when selected "On" from the front panel, or deactivated when selected "Off"]
PM1 N/A
PM1 N/A
*
*
(For the details about the Password Setting/Enable
and Unit Lock, , refer to the "Utility Menus Use"
* Section)
PM2 Enc. PM3 Enc.
Analog Same as PM2
Digital
Pink Noise
On Same as PM2
Off
-15 db Same as PM2
:
+15 dB
On Same as PM2
Off
000.0000mS 000.0000mS
[1 ms steps] [20.8 us steps]
600.0000mS 000.9984mS
5