Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS.-
This product must have an earth
connection. In the event that the
appliance malfunctions then the earth
connection will redirect the electrical
current away from the machine and
reduce the risk of an electrical shock.
This product is supplied with a mains
cable that has an earth wire and a
plug with an earth pin. The plug must
only be used with an appropriate wall
socket,
installed
connected to earth, in accordance with
local regulations.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock. If in doubt, get an
electrician or technical specialist to
check that the earth connection is
correct. Do not modify the plug
supplied with the equipment, if it does
not fit the wall socket then get an
electrician
to
socket that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Fig.A.
Make sure that the appliance is only
connected to a wall socket with the
same pin layout as the plug. Do not
use an adaptor with this appliance.
Always
observe
recommendations
electrical appliances:
1 Make sure that the mains supply
voltage matches that of the machine
correctly
install
an
electrical
the
following
when
before plugging it in. The supply
voltage must be the same as that
stated on the characteristics plate and
the holes in wall socket must match
the pins for plug on the machine.
2 To reduce the risk of electrical
shock, first put the switch to the "0"
position and then unplug it from the
wall socket. Always unplug the unit
immediately after use and before
proceeding to clean it.
3 Make sure that the treadmill is
and
switched off and unplugged before
beginning any type of maintenance or
assembly work on it.
4 Do not unplug the treadmill by
tugging on the mains cable.
5 Do not use the machine if the mains
cable becomes damaged or worn.
6 Keep the mains cable away from hot
surfaces.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect
both the electronic and electrical
circuits.
This
automatically triggered if the unit is
subjected to abnormal force or heat.
Should this occur:
1.- Set switch (L), located on the
casing, to the "0" (OFF) position Fig.B.
2.- Press the circuit button (C) to reset
the unit.
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again.
Should
repeatedly then the most probable
causes are:
-Abnormal working conditions,
using
-Treadmill belt in need of lubricant,
-Solvent based lubricants used,
- Belt is too tight.
16
safety
device
the
circuit
will
be
breaker
trip
Publicidad
