Publicidad
Idiomas disponibles
Idiomas disponibles
MOVEMENT & STORAGE.-
The unit is equipped with wheels (34),
Fig.7 to make it easier to move. Make
sure that the mains cable is unplugged
from the wall socket.
The treadmill has to be moved as
shown in Fig.7. Even though this can
be done by one person it is advisable
that two people are involved due to
the weight of the machine. It is very
important to grip the front section of
the machine, it must never be
moved
about
electronic monitor.
Once the machine is in an ideal spot
for use, lower it gently down onto the
floor.
To prevent accidents DO NOT move
the treadmill across uneven floors.
MAINTENANCE.-
Use the bottle of lubricant (85) to
lubricate the inside of the belt in order
to keep your unit in top condition and
to ensure that friction between the belt
and the board Fig.8 is kept to a
minimum (due to different running
styles, always apply more lubrication
to the area where you place your feet
during the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band every month, depending on how
often it is used.
Measurement
6KM/hr below 1 year
Metric
6~12KM/hr
12KM/hr above 3 moths
4mile/hr below 1 year
English
4~8mile/hr
8mile/hr above 3 moths
bygrabbing
Speed
Interval
6
months
6
months
Note: This preventive maintenance
schedule is only meant for home use.
It is suggested to maintain the unit
every month for commercial use.
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6mm Allen
key and with the machine set to 4km/h
turn screws (R & L) one turn in a
clockwise direction.
ADJUSTING THE BELT.-
the
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways. Rigorous
quality control adjusts and checks the
running belt. However, due to weight
differences and individual styles of
running, the belt may be prone to shift
sideways. If the belt does shift to the
left or right, stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important.
Follow these steps. In order to adjust
the belt, set the unit in motion at a
speed of 4km/h. If the belt has moved
to the right, turn screw (R) on the
right-hand side of the machine a 1⁄4
turn clockwise. Note the position of the
belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the left then turn
the right screw back slightly in an
anticlockwise direction. Fig.9.
As soon as you have adjusted the belt
you can begin exercising again.
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1⁄4 turn
clockwise.
18
Publicidad
