Omega Lift Equipment 44700 Manual De Usuario página 3

ASSEMBLY InSTRUCTIOn FOR MODEL 44700
(refer to Figure 2)
1. Insert the wide leg (#13) into tube welded at the end of boom (#1) and the narrow leg (#14) to boom extension (#2).
2. Slide transfer adapter (#11) over the end of boom extension (#2) with tube toward you.
3. Insert the boom extension (#2) into boom (#1).
nOTE: The Engine Transverse Bar may be used with or without support arm, depending on the load being supported.
4. To use without support arm: Secure both threaded hooks (#3) to the tube welded on boom and transfer adapter
with barrel hex. nut (#7). Thread the hex. nut (#7) all the way down towards the hook portion to hold it out of the
way until needed.
5. To use with support arm:
(a) Insert the adjustable leg (#6) to support arm (#10), then hand tight with M8x65 bolt and wing nut (#9 & 8). Do
not fully tighten wing nut as height adjustment may be necessary once the Engine Transverse Bar is placed
over the engine compartment of the vehicle.
(b) After determining the length of support arm needed, Connect the support arm (#10) to transfer adapter (#11)
on the boom extension with M12x120 bolt and wing nut (#5 & 4). Again, do not fully tighten as some length
adjustment may be required.
(c) Before placing the Engine Transverse Bar over the engine compartment, install the two threaded hooks (#3)
provided. Insert one hook to the tube welded on boom (#1) and secure with barrel hex. nut (#7). Thread the
hex. nut (#7) all the way down towards the hook portion to hold it out of the way until needed. Then, locate
the best position on the support arm for the second hook and install in the same manner.
6. Now the Engine Transverse Bar is ready to use.
Figure 2 - Model 44700 Assembly & Parts Illustration
3