Controls And Indicators - QSC GXD 4 Guia De Inicio Rapido

Outputs (Channels A & B)
Figure 2
See
4Ω or 8Ω impedance
CAUTIONG!: Do not combine the audio outputs in any way. Do not connect
the audio outputs to ground.
iring
Be sure to observe polarity.
• NL4 connector – See
• Binding Posts - Use banana plugs or wire directly
AC Power
ARNINNG!: The power cord shall be connected
EN
to a mains socket outlet with a protective earthing
connection.
See Figure 4
Connect the IEC power cord to the AC receptacle on the rear
of the amplifier.
Push to reset Breaker when necessary.

Controls and Indicators

Figure 5
See
1. Channel A CLIP indicator – illuminates red when the input is high
enough to cause the channel to clip.
2. Channel A SIG (signal) present indicator – illuminates green when
there is a signal applied to the input.
3. Power Switch/LED on/off – Illuminates blue when on.
4. Adjust Channel A GAIN
5. User Interface
a. HOME – go to HOME screen / view current PRESET
b. ENTER – select highlighted item and/or confirm parameter change
c. EXIT – return to previous screen and/or undo parameter change
6. Adjust Channel B GAIN, selects and adjusts controls
7. Channel B SIG (signal) present indicator – illuminates green when there is a signal applied to the input.
8. Channel B CLIP indicator – illuminates red when the input is high enough to cause the channel to clip.
Figure 3
Amplifier
GXD 4
GXD 8
GXD4 Outputs
— Figure 2 —
Power Consumption
Amplifier Voltage Current
GXD 4 100–240 VAC ~3.3 A – 1.6 A
GXD 8 100–240 VAC ~6.3 A – 3.6 A
— Table 3 —
1
A
CLIP
+
P1: ST SAT FULL RANGE
SIG
2
PROCESSING
GAIN
AMPLIFIER
3 4
3
Power Output
8Ω 4Ω
400 W 600 W
800 W 1200 W
— Table 2 —
Male NL4 Wiring
— Figure 3 —
Frequency
50/60 Hz
50/60 Hz
— Figure 4 —
A B
dB
-100 10.0
STATUS: OK
HOME ENTER EXIT
a b c
5
User Interface
— Figure 5 —
Max Peak
1600 W
4500 W
2-
1+
2+
1-
8
CLIP B
SIG
7
GAIN/DSP CONTROL
6