Trap Placement; Propane Tank Installation - Mosquito Magnet Liberty Manual Del Operador

Assembly Instructions
Step 17 Step 18
Align bottom of net guide over top Attach back of net onto tab provided
of black slotted collar. Slide net inside of net housing. Place excess
length of string towards door to
over collar. You will hear a click
when net is secured. avoid string getting drawn into fan.
Step 21 Step 22
Insert plume tube into trumpet by Using the built in handle on front of
aligning slots in tube with tabs in Liberty, move your trap top desired
power head tube. Turn clockwise location in yard. See "Trap
until secure. Placement" instructions on page 8.
Step 25 Step 26
Clip tether from bottom of the Liberty Attach propane regulator hose to
power head around tank handle. propane tank. (Make sure propane
Tighten securely making sure not to tank is fully closed). Secure tightly
dislodge tank from cradel position. by hand. Do not use tools.
Step 28
Plug power adapter into properly
grounded electrical outlet.
7
Step 19 Step 20
Close net door and lock by turning Locate black plume tube and hold
latch to the left. Trap will not with slotted side up.
maintain catch properly if net is
not inserted correctly.
Step 23 Step 24
Insert attractant as directed in Place propane tank (not included)
attractant packaging. into round cradle hole in base.
Step 27
Plug power connector into the
Liberty unit power slot located on
the back of the power head.
Step 29
Turn propane valve on slowly.
Follow "Starting Instructions" on
page 11.
Set-Up

Trap Placement

1. Determine the direction of the prevailing wind.
Check local weather patterns if you are unsure.
2. Stand in the center of the area you are trying to
protect and look toward the prevailing wind.
3. Proper placement of the Liberty will be 30 – 40 feet
in front of you, within 5-6 feet of ground cover (i.e.
bushes, flowerbeds, tree line, marshbed). Ensure
that trap is not directly against any blockades such
as buildings, fences, etc.
4. It is recommended that the trap be placed in the shade.
5. Do not place trap directly above a water source
(sprinklers, hose, etc.).
6. Trap must be placed on level ground to avoid tipping
or uneven propane distribution.
7. For optimal trap placement in your yard, refer to the
instructional CD-ROM included with your Liberty.
Burying the Power Cord
Make sure unit is unplugged and in proper position. Use
the Cord Burying Clips supplied. Place clips approximately
3 feet apart, press into ground by hand making sure not
to damage power cord. For alternate placement, follow
steps illustrated below.
1. Use straightedge shovel or garden spade and dig a
trench about 3"-4" deep from power source to trap.
2. Place cord into trench carefully stretching as you go
to remove any twists in cord.
3. Use cedar shingle or folded cardboard to place cord into
bottom of trench. Recover the trench with removed soil.

Propane Tank Installation

1. After trap is placed in its ideal location, place propane
tank onto the molded cradle.
2. Make sure propane tank is fully closed. Attach
propane regulator hose to propane tank. Secure
tightly by hand. Do not use tools.
3. Turn propane on by slowly turning valve counter-
clockwise. Take care not to turn too quickly to avoid
engagement of safety valve.
DO NOT MOVE TRAP WITH TANK ATTACHED!
TANK MUST BE DISCONNECTED FROM REGULATOR
BEFORE TRAP IS RELOCATED TO AVOID DAMAGE TO
REGULATOR AND/OR TRAP. BE ADVISED, DAMAGE
CAUSED FROM FAILURE TO COMPLY WITH THIS
INSTRUCTION IS NOT COVERED UNDER WARRANTY.
Step 1 – Propane Tank Placement
Step 2 – Attach Regulator Step 3 – Slowly Open Valve
8