Common Malfunction & Removal - Viesta Eco 100 Instrucciones De Uso

Common malfunction & removal
1. The glimmering of function indicator lamp(21): Check if the coff ee dump
container(3), the drip tray(1) and the brewing unit(15) are ail fi xed properly.
( After long distant shipment, some of them may not be in its original place).
2. The all-time lighting of function indicator lamp(21): reopen and close the
swinging door(4) of the machine.
3. The simultaneous glimmering of water temperature indicator lamp(18) and
steam indicator lamp(20): Put an empty cup under the milk frother(13) and
revolve the hot water & steam knob(12) to release some steam and water until
the steam indicator lamp(20) stops glimmering and water temperature lamp(18)
turns solid. The coff ee then can be made.
4. No water of coff ee comes out to the cup while grinder fi nished it grinding beans:
Check the bean powder in the coff ee dump container(3), if it is not enough
water, refi ll the water then release the water by rotating hot water & steam
knob(12) until water comes out, or you may wait 10 minutes for automatic
cooling down of the boiler, then release the water by rotating hot water by
rotating hot water & steam knob(12), then press the coff ee making button(17)
to make coff ee. B. Please check the sieves in the brewing unit(15), see if they are
jammed or not, if jammed, please clean them with brush and water. C. The pump
maybe doesn't work well, it needs professional maintenance.
D. The driving motor behing the brewing unit(15) may lose its partial driving
force, it also needs professional repair.
5. Cold coff ee: After a few cups of hot coff ee, suddenly comes out cold coff ee.
That means heater(boiler) does not work because the temperature controlled
switch (which is attached under the heater) dropped, you must open the
machine, press upward the switch to make it attach the heater tightly again.
Please pay attention, there are two white big switches, On the big switch there
stands a small white pin on each one, what you need to press is the small pin,
please press both of pins.
6. The brewing unit(15) can be put back into the machine: Firstly, check the
brewing unit, confi rm if you can see the bottom sieve from the funnel, because
after cleaning the brewing unit, you may draw out the movable lower part which
powder is pressed and irrigated there. If you can not see the bottom sieve from
the funnel. You may just catch the "tongue-like" piece to push upper direction
reaching the top. Then put back the brewing unit (15). Secondly, the brweing
unit is ok, you may check a white big spindle in the machine, you can see the
white big spindle, while you draw out the brewing unit(15). The white spindle
wrongly stop while it is rotating, you may power on the machine, then use two
screw drivers, one plunges the switch on the board, the other to the switch near
the upper part of the steam pipe.
The white spindle will rotate to its originalplace.
[ EN p. 14 ]
Version: 8.0
KEN001KVA 19.09.2017