Snooze Function - ECD XMS 1111 U Manual De Instrucciones

Activation/deactivation of the alarm
• If you want to activate previously set alarm, press the appropriate button ALARM (1 or 2) so that the alarm
clock symbol appears on the display
If you want to deactivate the alarm, press the appropriate button ALARM (1 or 2) so that the alarm clock
•
symbol disappears from the display
Radio, CD or buzzer alarm
• CD, radio or buzzer will sound in the preset time. The alarm clock turns o after 60 minutes and is set
automatically for next day (provided the SNOOZE button was not pressed). After alarm sounds, you can
press the button SNOOZE to activate the snooze function. The alarm clock pauses for 9 minutes and then
starts again. You can repeat the snooze function of the alarm again and again for the remaining 50 minutes.
• If you want the stop the alarm, press the appropriate button ALARM 1 or 2 on the remote control or the
button POWER 1 on the device. The alarm clock automatically sets for next day.
Note: If you press during the alarm the button
control, the device will stop the alarm and switches to a selected mode.
GB
• If you want to cancel alarm for next day press repeatedly ALARM 1 or 2, until the indicator of the alarm
clock ( /

Snooze function

The snooze function allows you to delay the active alarm by 9 minutes. If you want to do so, press during the
alarm the SNOOZE button once. The alarm stops and starts 9 minutes later. During this time the alarm clock
icon ashes. If you want to turn o this function, press the POWER 1 button. The icon SNOOZE disappears and
the alarm clock icon stops ashing.
Radio
1. Press POWER 1 to turn the device on.
on the device or press FUNCTION on the remote control to select the radio mode, the display
2. Press
shows "FM" and radio frequency.
3. Press repeatedly the buttons
nd stations, which were skipped during automatic tuning.
4. If you want to tune automatically the closest available station, press and hold for 2 seconds the button
or , until the frequency on the display starts to change. Then release the button. Once the radio tunes to
a station with a strong signal, the searching of frequencies stops.
5. Adjust the volume using buttons
FM and Stereo FM reception
If the station broadcasts in stereo, you can press FM ST/MODE to switch between the mono and stereo
•
reception. An indicator "ST" appears on the display. If the station signal is weak, it is better to turn o the
stereo reception.
• For optimal reception quality extend as much of the FM antenna as you can.
Presets of radio stations
You can store up to 20 radio stations in the system memory.
Press POWER 1 to turn the device on.
1.
Press FUNCTION to select the radio reception mode.
2.
3. Using manual or automatic tuning, tune in the station that you want to store.
4. Press the button PROG/PRESET. The number of the rst preset starts ashing (e.g. "P01", if performed for
the rst time).
5. Using the buttons v or V select the required number of the preset where you want to store the currently
tuned in station.
6. Press SELECT to con rm your selection.
7. Store other presets by repeating steps 3 to 6.
62
62
XMS 1111 U_manual_cz_sk_pl_hu_de_gb_hr_si_sr_fr_it_es_et_lt_lv.indb 62
or
or
) disappears.
/
to tune manually the required radio station. Use manual tuning to
on the device or VOL+/- on the remote control.
. The alarm will sound in preset time.
. The alarm is now deactivated and will not sound.
on the device or the button FUNCTION on the remote
17.07.2016 16:00:44