Using Headphones; Care And Maintenance; Cleaning The Device; Troubleshooting - ECD XMS 1111 U Manual De Instrucciones

• Do not charge a phone continually for longer than 12 hours. After a full charge of the phone or other
portable device, disconnect the device from the USB port.

Using headphones

Connecting the headphones (not included) to the headphones jack of the device allows for private listening.
When using headphones, the speakers of the device are automatically disconnected.
• Avoid prolonged loud listening through headphones. Long-term loud volume can damage your hearing.
• If you hear ringing in your ears, reduce the volume or stop listening.
• Do not set an unnecessarily high volume, even if your headphones are of the open type. Too loud volume
prevents reception of surrounding sounds.

CARE AND MAINTENANCE

• Do not expose the device to bumps and jolts, to dust or extreme temperatures.
• Do not tamper with the internal parts of the device.
• Clean the device using dry cloth. Do not use cleaners or solvents.
• Do not leave the device in direct sunlight or in hot, humid and dusty places.
• Keep the device away from heaters and sources of electromagnetic interference, such as e.g. uorescent
lights or motors.
• If when playing CDs occur stoppage or skipping in playback, clean the disc using special cloth. Wipe the
disc with short moves from the center the edge.

Cleaning the device

• Before cleaning, disconnect the unit from the power supply to avoid electric shock.
• Clean the surface of the device using a duster or dry cloth. Do not use any chemical cleaning supplies.
• If the front panel is dirty, you can clean it using a cloth slightly dampened with a weak detergent solution.
Never use abrasive sponges and powders, which could damage the surface nish of the device.
Prevent water from penetrating the device!
•

TROUBLESHOOTING

Before taking the device for repair please read the following instructions.

Reset the device

If the device does not respond or shows abnormal behaviour it may have been exposed to electrostatic
electricity or surges that cause blockage of the internal processor of the unit. In this case, unplug the AC
adapter, wait 10 minutes and then reconnect the power. The device resets, therefore you will have to set again
the clock, the alarm and the preset radio stations.
Troubleshooting
Symptom
No power
No sound
Cannot play disk
Skipping or
intermittent sound
from CD
The device does not
react to commands
XMS 1111 U_manual_cz_sk_pl_hu_de_gb_hr_si_sr_fr_it_es_et_lt_lv.indb 65
Cause
• The power supply is not properly connected to the
socket.
• The volume is set to minimum or the audio is o .
• The disk is inserted improperly.
• The disk is not compatible with this device.
• The disk is dirty.
• Dirty or scratched disc.
• The lens of the player is dirty.
• The device is exposed to strong vibrations or jolts.
• Static electricity etc. interferes with the device.
Correction
• Check the proper connection of the power supply.
• Raise the volume using buttons VOL+.
• Make sure the disk is inserted with the label facing
upward.
• Use a compatible disc.
• Clean the disk
• Clean the disc or use another disc.
• Use cleaning disc to clean the lens of the player.
• Put the device in place protected from vibrations.
• Turn the device o and unplug from the socket. Plug the
power cord back in and turn on the device.
GB
65
65
17.07.2016 16:00:44