Hand blender Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
DO NOT ALLOW CHILDREN, DISABLED PEOPLE OR
EVERY PEOPLE WITHOUT EXPERIENCE OR TECH-
NICAL ABILITY
TO USE THE APPLIANCE IF THEY
ARE NOT PROPERLY WATCHED OVER. CLOSE SU-
PERVISION IS NECESSARY WHEN ANY APPLIANCE
USED BY OR NEAR CHILDREN.
MAKE SURE THAT CHILDREN DO NOT PLAY WITH
THIS APPLIANCE.
IF YOU DECIDE NOT TO USE THE APPLIANCE ANY LONGER,
MAKE IT UNSERVICEABLE BY SIMPLY CUTTING THE SUPPLY
CABLE AFTER DISCONNECTING THE PLUG FROM THE SOCKET.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
WARNINGS FOR USE
Before using the blender, check its integrity and the one of power
cord.
Pay close attention to the cutting blade particularly when the plug is
plugged in the socket.
Before removing the ingredients, which attached to the blade during
processing, disconnect the plug from the socket.
Do not operate the blender for more than 30 seconds, to avoid
overheating, and wait at least 5 minutes before using it again.
Use the hand blender on a horizontal surface.
Do not immerse the motor unit in water or other liquids.
Before assembling, disassembling or cleaning the hand blender
unplug it from the mains socket.
8