NZI Helmets FIBR UP Manual De Usuario página 10

Place the visor over the helmet in the position
that it will have, as it would be in completely
opened position. Hold the part of the visor
slotting into the visor mechanisms over them.
Pull the lever as it is shown by the arrow until
it reaches its maximum displacement and in-
sert the visor in its place, when doing this in-
troduce first the circular zone in its place and
then introduce the geared part.
Release the lever. Open and close the visor
several times to make sure it has been well
assembled.
GB DETACHABLE COMFORT PADDING
Your helmet is equipped with detachable com-
fort padding. You can wash the comfort pad-
ding. To clean the padding, once disassembled,
it is recommended to wash it by hand with
neutral soap and let it dry without exposing it
to the sun.
Assembly and disassembly of the comfort
padding.
Side cheek pads.
Disassembly:
10
O W N E R S
Pull out the cheek pad carefully until the press-
studs are released. (Fig. 11)
Assembly:
Relocate the cheek pad and fixate it with the
press-studs. (Fig. 1 2)
Comfort padding change.
Disassembly:
Once you have disassembled the side cheek
pads, take out the screw that fixes the cheek
Fig. 11
pad support to the helmet (rotate it 90º clock-
wise. Fig. 1 3), you can use a coin for this. Pull
out the side protection padding carefully, so
that you can extract the neck comfort padding
M A N U A L
Fig. 12