NZI Helmets FIBR UP Manual De Usuario página 11

O W N E R S M A N U A L
from its position (Fig. 1 4). Repeat the same op-
eration on the other side of the helmet. Pull out
the central part of the neck comfort padding
carefully, so it gets out of its position (Fig. 1 5).
To extract the comfort padding completely,
pull out the front part carefully until it is com-
pletely released from its position (Fig. 1 6).
Fig. 15
Fig. 13 Fig. 14
Assembly:
Insert the front part of the central comfort
padding in its position first and then the rear
part, the neck protector. Fix the lateral parts
of the neck comfort padding.
You have to align the holes on the outer shell, GB
on the lateral part of the neck protector (piece
B, Fig. 1 7) and on the side protection padding
Mov. 1
(piece C, Fig. 1 7). Insert the fixation screw
through them (piece A, Fig. 1 7) with
'Movement 1', as indicated in Fig. 1 7. After this,
turn the screw 90º anticlockwise. (Mov.2, Mov. 2
Fig. 1 7)
A
Fig. 16
Fig. 17
B
C
11