Specifications; Maintenance Tips - General MMD900 Manual Del Usuario

SPECIFICATIONS

Measurement Ranges
Measurement Accuracy
Length of Test Pins
Length of Remote Cable
Measurement Depth (pinless mode) 2 in. (51mm)
Pinless Sensing Area
LCD Range/Size
LCD Resolution
Bar Graph Composition
Bar Graph Resolution
Auto Power Off
Low Battery Warning Level
Current Consumption
Calibration Point
Operating Temperature
Dimensions
Weight
Power Source

MAINTENANCE TIPS

When the
the 9V battery that powers the meter (although measurements will remain valid
for several hours after the icon first appears).
When the tips of the meter's factory-installed 15mm test pins, or the tips of the
10mm factory-installed test pins on the remote probe show signs of wear,
replace them with a pair of 10mm or 15mm pins included in the case.
Remove the battery when storing the meter for an extended period of time.
Never drop or disassemble the meter or immerse it in water.
10
icon appears at the upper left of the LCD, it's time to replace
6.0 to 87.6% WME and 0.1 to 99 REL
±3% in pin mode
15mm (0.6 in.) on top of meter; 10mm (0.4 in.) on
remote probe; 10mm and 15mm (spares)
46 in. (1.168m)
1.6 x 1.6 in. (40 x 40mm)
6.0 to 87.6 count with 0.9 in. (23mm) high digits
0.1%
40 LEDs of 3 colors: green (0 to17%), yellow
(17 to 30%) and red (>30%)
±1 LED (±2.5%)
After 3, 5 or 10 minutes (user selectable) with
0% reading
<6.5VDC
<70mADC
18.2%
32° to 122°F (0° to 50°C) @<80% relative humidity
9 x 2.75 x 1.625 in. (229 x 70 x 41mm)
8 oz. (249g)
9V battery (included)