Environmental Protection; Technical Specifications - Metabo RB 18 LTX 60 Instrucciones De Manejo

the rate of current increase is too high (if the
machine seizes suddenly), the machine switches
off. Switch off the machine at the slide switch (7).
Switch it on again and continue to work as normal.
Try to prevent the machine from seizing.
- Restart protection: The machine does not
start. The restart protection is active. If the mains
plug is inserted with the machine switched on, or if
the current supply is restored following an inter-
ruption, the machine does not start up. Switch the
machine off and on again.
8.2 Cordless machines
- The electronic signal display (5) lights up and
the load speed decreases. The temperature is
too high! Run the machine in idling until the elec-
tronics signal indicator switches off.
- The electronic signal display (5) flashes and
the machine does not start. The restart protec-
tion is active. The machine will not start if the
battery pack is inserted while the machine is on.
Switch the machine off and on again.
9. Accessories
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating instruc-
tions.
For a complete range of accessories, see
www.metabo.com or the main catalogue.
10. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.

11. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Special instructions for cordless machines:
Battery packs must not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Before disposal, discharge the battery pack in the
power tool. Prevent the contacts from short-circu-
iting (e. g. by protecting them with adhesive tape).

12. Technical specifications

Explanatory notes on the specifications on page 4.
Changes due to technological progress reserved.
U = Voltage of battery pack
I = Current at 120 V
120 V
P = Nominal power input
1
P = Power output
2
B = Sanding belt width
B
B = Sanding belt length
L
D = Machinable tube diameter
U = max. angle of contact
a, max.
v = Belt speed in idling
0
m = Weight with smallest battery pack/weight
without cord
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
RBE 9-60: Energy-rich, high-frequency interference
can cause fluctuations in speed. However, the
fluctuations disappear as soon as the interference
fades away.
Wear ear protectors!
ENGLISH en
9