Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. Accessories
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
For a complete range of accessories, see
www.metabo.com or the catalogue.
12. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.
13. Environmental Protection
The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
14. Technical specifications
Explanation of details on page 3. Subject to change
in line with technical advances.
D
= max. diameter of accessory
max
t
= Max. permitted thickness of clamping
max,1
shank on accessory when using
clamping nut (10)
M
= Spindle thread
l
= Length of the grinding spindle
n*
= No-load speed (maximum speed)
I
= Current at 120 V
120 V
P
= Nominal power input
1
P
= Power output
2
m
= Weight without mains cable
* Energy-rich, high-frequency interference can
cause fluctuations in speed. However, the
fluctuations disappear as soon as the interference
fades away.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
Using these values, you can estimate the
emissions from this power tool and compare these
with the values emitted by other power tools. The
actual values may be higher or lower, depending on
the particular application and the condition of the
tool or power tool. In estimating the values, you
should also include work breaks and periods of low
use. Based on the estimated emission values,
specify protective measures for the user - for
example, any organisational steps that must be put
in place.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
= Vibration emission level
h, F
(routing)
a
= Vibration emission level
h, S
(grinding)
K
= Uncertainty (vibration)
h,...
Wear ear protectors!
ENGLISH en
9
Publicidad
Tabla de contenido
