Adjusting The Belt Tracking; Adjusting The Motor Mount Tracking; Re-Positioning The Table Height - Delta 31-482 Manual De Instrucciones

TO AdjUST ThE BELT
TRACKINg
Tools Needed: Belt Tracking Tool (provided)
Before making any adjustments to the
tool, disconnect the machine from the
power source.
1. Rotate the belt by hand from left to right and
observe whether the belt is tracking above or below
the edges of the rollers.
2. Using the belt tracking tool (provided) loosen the
micro adjust lock nut.
3. Based on whether the belt is tracking up or
down, turn the micro adjusting screw in 1/4 – turn
increments to the left or right until the belt tracks
MOTOR MOUNT TRACKINg
AdjUSTMENT
Tools Needed: Two 1/2" Wrenches
Note: The Motor Mount Tracking Adjustment is a
course adjustment. Use the Belt Tracking Adjustment
first for fine adjustment. If it cannot be adjusted, then
use the procedure described below.
Before making any adjustments to the tool, disconnect
the machine from the power source.
1. Loosen the four motor mount
nuts (A) just enough so the tracking
screws can be turned to make an adjustment. See
Fig. 11.
2. Loosen the two locking hex nuts that secure the
tracking screws.
3. Turn one screw a 1/4-turn and rotate the sanding
belt by hand to observe which direction the
adjustment is causing the belt to move. If it is
TO AdjUST ThE SANdINg
TABLE hEIghT
Before making any adjustments to the
tool, disconnect the machine from the
power source.
Never position the sanding table below
the sanding belt! Keep an overlap
of at least 1/16" between table and sanding belt to
avoid material and/or fingers getting caught! Failure to
comply may cause serious injury!
1. There are two height elevation lock knobs (A) one
on either side of the table support, shown in Fig. 12.
Loosen both lock knobs just enough to allow the
sanding table to move up and down.
AdjUSTMENTS
evenly on the rollers when rotated by hand. See
Fig. 10.
4. Re-tighten the micro adjusting nut.
NOTE: The Belt Tracking Adjustment provides a minor
adjustment that
should correct
most tracking
problems. If
the tracking
problem persists,
use the Motor
Mount Tracking
Adjustment (next
section).
traveling in the direction needed to correct the
problem, go to step 5.
4. If the belt tracks in the wrong direction, back off
a 1/4-turn and tighten the other screw a quarter
turn. This should start the belt moving in the proper
direction.
5. Tighten both
locking nuts and
motor mount
nuts.
6. Return to the
Belt Tracking
Adjustment
section (previous
page) to fine tune
the tracking.
play in table Failure to comply may cause serious injury!
2. Raise or lower
work table to
desired level.
3. Tighten the
lock knobs.
12
The table is very heavy. Loosen lock
knobs slowly and just enough to create
FIg. 10
FIg. 11
FIg. 12