Advanced Programming - Telecom TANGO SW BLEU Manual De Instrucciones

GB
- Brief flash of one led: when transmitting with a correctly memorised
radio control, and the respective relay is activated.
- Simultaneous blinking of all the LEDs: during programming this indi-
cates that a transmitter that is already enabled is being memorised.
- Alternate blinking of the LEDs: during programming this indicates that
the storage is full.

ADVANCED PROGRAMMING

The mode of operation may be changed in the receiver relay outputs,
making them versatile for various uses.
A ttention! Do not set options given in this section with button P1 of
The TANGO SR SW and FOX SR receiver.
1. Single-step output
- During programming press key P2 twice instead of once as described
in paragraph 2 under the heading "Standard programming".
- The led related to the pressed button gives 5
series of two blinks.
- During this stage, transmit with a transmitter.
- A fixed led light for a few moments indicates that
memorisation has been successful. The P2 output
is now single-step. The output has no magnetic hold, so if there is a
power failure while the relay is activated, the latter deactivates.
2. Timer output
- Press the key P2 3 times during programming.
- The led related to the pressed button gives 5
series of three blinks.
- Transmit with a remote control during this stage.
- A fixed led light for a few moments indicates that
memorisation has been successful. The P2 output
has now become a timer.
38
2
P2 L2
( ( P3- -LL3)
( ( P4- -LL4)
3
P2 L2
(P3 - L3)
(P4 - L4)